This is a new improved version of the application IOScomm.
Previous applications supported routers only, and in the future will not be upgraded.
It is recommended that you uninstall the old version of the application and set a new one (although both will work independently at the same time).

IOScommands covers Cisco routers and switches.

For routers, covered the following areas:
1. GENERAL
2. ROUTING-GENERAL
3. ROUTING-STATIC
4. ROUTING-RIP
5. ROUTING-EIGRP
6. ROUTING-OSPF
7. INTER VLAN ROUTING
8. PPP
9. FRAME RELAY
10. SECURING THE ROUTER4
11. CDP COMMANDS
12. IP COMMANDS8
13. IPX COMMANDS
14. ACCESS LISTS
15. DHCP
16. NAT
17. IP v6
18. WAN CONFIGURATIONS
19. TROUBLESHOOTING TOOLS

For switches, covered the following areas:
1. GENERAL
2. CONFIGURE IP CONNECTIVITY
3. CONFIGURE A WEB INTERFACE
4. BACKING UP A CONFIGURATION
5. DHCP SNOOPING
6. CONFIGURING PORT SECURITY
7. VLAN CONFIGURATION
8. CONFIGURE THE NATIVE VLAN
9. DTP TRUNKING MODES
10. VLAN FOR VOICE
11. VTP - VIRTUAL LAN TRUNKING PROTOCOL
12. STP - SPANNING TREE PROTOCOL

此版本中的新功能：